Wood Floor In Bathroom Sealing

The oil is applied diluted 50 50 with white spirit and will penetrate the wood by perhaps 1 8 of an inch.

Wood floor in bathroom sealing. The bathroom can get quite humid while people are having showers etc and in winter it can take some time to fully dry out. You can also buy wool applicators. Allow to dry for 24 hours. Allow the caulk to dry for 24 hours before installing the finish flooring.

Add the first coat of sealer to your wood floor using an old fashioned trick. Use 100 grit dust or finer. Using this material will ensure a smooth and even first coat which is important for an equally even final result. I want to avoid any mould growth or other damage from moisture.

Fill any cracks in the floor as well. Collect fine dust from wood that is the same type as your floor. Cracks and gaps will attract moisture so sealing them completely is an important step in making sure your floors are entirely waterproofed. I have nearly finished making a small table which will be placed in a bathroom.

Caulk any splits in the wood or any other areas that may provide a point for water to seep under the subfloor. I am concerned about protecting the wood in a humid damp environment. When water is left on top of the planks they crown the middle swells up. Beech and maple are.

If you don t have a piece of wood left over from the initial installation of your floor try to find sanding dust from a piece of wood that is the same kind and color. Using a caulk gun and silicone seal fill the seams between the floor and the wall. Manufacturers often challenge warranty claims on wood flooring in a bathroom and some flooring products may expressly say they are not suitable for bathrooms. If moisture seeps down past the surface it can get to the structural components of the floor and start eating away at the subfloor and underlayment.

Many hardwood floors are installed by nailing planks directly to the subfloor which means that a traditional vapor barrier can t be used since the nails would puncture it. Moisture rising from under the floor tends to make planks cup so that they dip in the middle. Spread the urethane with a wool mop or any mop made of thick natural material. Caulk any seams where two pieces of plywood are butted together.

You will need som patience to oil the wood as the rule of thumb is 1 coat per day for a week then 1 coat per week for a month then 1 coat per month for a year. The amount of sanding dust you ll need will depend on the size of your project.